We Buy & Sell All Types of

Cemco Turbo Vertical Shaft Impact Crusher, VSI, model MDEV80, Turbo80. Crushing chamber measures 6' diameter X 4' high sidewall, with 35" diameter Superchipper rotor assembly. Product is fed through 15" diameter center top opening thru rotor with 12" x 8" openings, spreading feed material into crushing chamber. Inside wall includes heavy duty anvil ring with stationary anvils along circumference of chamber. Rotor is driven by twin drives, 250 HP and 150 HP (460 volt, 1785 RPM, 3/60Hz) thru V-belt assemblies, connected to common sheave. Product discharges through 36" x 15" split discharges. Top cover is removeable with swing assembly, controlled by manually operated hydraulic cylinder. Serial# 4156.

Allis Chalmers Svedala Ball Mill, 13' diameter x 21' long, rubber-lined mill, with Siemens-Allis 2,000 HP, 4000 volt, 200 RPM synchronous motor, Eaton airflex clutch. Includes trommel discharge, ball mill rejects conveyor, lube system, etc. Offered complete with controls. New in 1979. Completely rebuilt in 1998, serial number C-2485. Previously used at phosphate minerals processing facility. Also available pumps, spare parts, drives, controls to comprise of complete mill system. Equipment was dismantled and is now being stored at crane yard for easy loading.

FAM Double Roll Crusher, 78" diameter x 60" wide (2000 mm x 1500 mm) rolls, heavy duty teeth, manufactured by FAM, type ZWB 2015 HSm, up to 24" feed size, (1) roll is hydraulically adjustable for roll gap spacing, rolls driven by twin 350 HP, 4000 volt, 1187 RPM, 60 Hz motors thru gear reducers. Complete with lube system, discharge chute, hydraulic pump station, controls, etc. Previously used as primary crusher at phosphate minerals processing facility. Apron feeder also available. Equipment has been dismantled and is now being stored at crane yard for easy loading.

5' diameter X 6' long ball mill, manufactured by Patterson Industries, Type D, non-jacketed, with AR400 steel liners. Includes 30 HP, 3 phase, 60 Hz, 230-460 V, 1725 RPM motor. Mill drive is integrally coupled to horizontal parallel shafted helical gear reducer. Continuous type, with product feeding through spiral inlet trunnion and exiting through the discharge end trunnion. Features cylinder manway access door for cleaning. Internal volume measures approximately 839 USG (112 CF). Mill shell is lined with (24) 1/4" thick liner plates, each head lined with (8) 3/8" thick pie-shaped liner plates. Mounted on stand with approximately 66" clearance between the mill cylinder and floor. Mill was intended for use in glass particle size reduction but were never installed. Manufactured in 2019, unit is still in factory plastic wrap and in new condition.

45" diameter x 48" long ball mill, manufactured by Paul O. Abbe Ball Mill, Model 4-A, rated for 330 Gallon capacity, 44 cubic feet. Previously used as dry grind mill to process precious metal scrap into a 70 mesh material. Last used with timer control panels so that the units would operate for a specific cycle time and then automatically shut off to optimize the cycle time. Mounted on frame. Mill was well maintained and in good working order when removed from service in 2020. Includes ball charge.

View Our Inventory