Visit Wise Pool & Spa at 8341 Old Leonardtown RD in Hughesville today!

Anchor Safety Pool Cover

Care & Tips

 
Anchor Safety Pool Cover Wise Pool and Spa
Anchor Safety Pool Cover Care and Tips

In this short video, you will learn helpful tips to care for your Anchor Safety Pool Cover during the winter months. Highlights include:


  • Removing Debris
  • Snow & Debris Loads
  • Cleaning
  • Automatic Pool Cover Pump
 

Care & Tips

 

Pool Water Level - Maintain the pool water level at the middle of the skimmer (for vinyl pools with Aquador Skimmer Lids) or 2" below the skimmer (for vinyl pools without Aquador Skimmer Lids and plaster/pebble pools) during the off-season. If the pool water drops below these levels, the pool cover may experience stress. Never cover the pool without the proper pool water level under the pool cover. The pool water supports the weight of the pool cover. If the pool water level is low and precipitation accumulates on the pool cover, severe damage may occur to the coping and/or pool cover.

Snow Loads & Leaves - Powder snow and leaves can be blown off of the pool cover with a leaf blower. Wet snow can be dragged to the side of the pool cover with a telescopic pole with nylon only bristle pool brush and then removed.

Cleaning - Regularly remove any twigs, leaves, or other large debris from the surface of the pool cover. Failure to remove debris could result in damage to the pool cover and accumulation of organic residue and/or water. Keep your pool cover in the best possible condition by cleaning every 3-6 months with the cover pump in place. Use a soft bristle brush and fresh water to scrub the pool cover gently and rinse with fresh water afterward. For oils and stubborn stains, use a soft bristle brush and fresh water with a small amount of mild detergent such as Dawn dish soap to scrub the soiled area gently, rinsing well with fresh water afterward. Never use harsh chemicals to clean the pool cover, such as pool chlorine or algaecide, as these may damage the pool cover.

Periodic Pool Cover Visual Inspections - It is best practice to visually inspect your pool cover 2-3 times a year. Signs of deterioration include brittleness, cracking, fraying edges, holes, tears, and areas of wear. Also check the pool cover brass anchors, straps or springs/covers, to ensure that the fastener items which hold the cover in place are in good condition and not damaged, loose, or missing. Patch kits are available for small repairs to the cover and fastener items are regularly stocked in our store. Contact our Service Department for assistance if required.

Other - Always place a pool cover pump on a pool cover to regularly remove water from the cover. An automatic pool cover pump is ideal. The pool cover pump should be placed onto the pool cover at the side of the pool at the deep end, pushed to the center of the deep end using a telescopic pole with nylon only bristle pool brush, with the drain hose oriented away from the pool, and plugged into a GFCI protected outlet. When storing your pool cover, store a clean, dry pool cover in a cool, dry place away from direct sunlight. Use a storage bag or container to protect it from pests and damage.

 

Need Help?

 

Need help with your

Anchor Safety Pool Cover?

Contact our Service Department Today!

 
 
[Caption]
Facebook  Pinterest  Youtube  
[Caption]