SuperBOT 5 a/e comes with fully automatic operation setup capabilities and supports up to 2,100 UPH for devices with programming time less than 50 seconds

Built-in hardware: 4-8 high-speed universal programmers, SuperPro® 7500s
ARM11 32 bit MCU combined with an internal Linus operating system for optimal performance
Supported devices: EPROM, Paged EPROM, Parallel and Serial EEPROM, FPGA Configuration PROM, FLASH memory (NOR and NAND), BPROM, NVRAM, SPLD, CPLD, EPLD, Firmware HUB, Micro controller, MCU, and more
Packages: PLCC, JLCC, SOIC, QFP, TQFP, PQFP, VQFP, TSOP, SOP, TSOPII, PSOP, TSSOP, SON, EBGA, FBGA, VFBGA, uBGA, WLCSP, SCSP, and more.
Chip size: 2mm-25mm

Dual Manual Tray

This device is an extension of the fixed tray. It includes tray-in and tray-out. Users can insert 20 trays into the device. Trays can be automatically changed without the need to open the upper cover, which saves tray changeover space and prevents human error during tray changeover.

Our reliable tape-in feeders have been proven to meet all demands running 24 hours 7 days continuously
Tape width between 8 and 44mm applicable.
Tape-in device can be configured as per the chip to be programmed.

Operable Chip Size: Minimum 2x2mm; Maximum 25x25mm
Maximum Throughput: 2,500 units per hour (UPH) for devices with programming time less than 50 sec.
Suitable for both small and large capacity devices.
Some high pin-count devices will require both a programming socket adapter as well as a 100-pin driver expansion module. The benefit of this approach is that the socket adapter will be a universal adapter, which means it is able to accommodate any device up to 100 pins that has the same physical dimensions. The search results will indicate if the expansion module is required. However, for SuperPro 6100 and SuperPro 7500 you won't need an expansion module anymore since they come with 144 pin support by default.

Check out more of our Google reviews here.