|
Entry Water Features: We cleaned all the debris baskets and added chlorine shock to each feature. There is no incoming power to the South feature. Please contact CenterPointe to have this issue resolved.
Villages III: We collected trash from the lake and shoreline. The lights and timers are functional and accurate. The fountain is running and flowing properly. We treated for submerged algae along the bulkhead.
Switchback: The crew collected trash and debris. The lights and timers are all functional and accurate. Upon arrival, fountain #3 was not running. It performed well on our field diagnostic tests, so we reset it and will check back during our Stone Gate maintenance visit to ensure it is still running. The other three fountains were running and flowing properly. We treated for algae. The outfall was cleared of debris, and the water level is normal.
Willow Ranch: Trash and debris were collected. The lights and timers are functional and accurate. Both fountains are running and flowing properly. The crew treated for submerged algae. The outfall was cleared of blockages.
Nautical Point (Lake 4): Trash was collected. The lights and timers are functional and accurate. The fountain is running properly. The crew treated for algae along the bulkhead.
Nautical Point (Lake 5): We collected trash and debris. The lights and timers are functioning properly. The fountain is running properly. The outfall is clear of blockages.
Mariner's Bay: The crew collected trash and debris. The lights and timers are functional and accurate. Both fountains are running and flowing properly. We treated for submerged algae.
Additionally, we drove through the Stone Gate route to make sure all the fountains were running. Fountain #2 in Harmony Springs still has no incoming power. All other fountains were running properly. We noticed the water level in Bluff Springs was low, so we turned on the well to allow it to return to normal.
Trash was cleaned up around the Rec Center.
The walkway at the Splash Pad.
Fixed stones around flowerbed at the Rec Center.
Fixed door handle at Newlight Bend. Had to take it apart and reassemble. The handle was operating properly.
Gate Updates for week of 06/24 – 06/28
Monday:
Mariners Bay: Exit gate was half opened as there was a miscommunication between operators; Reset communication and the gate is operational.
Mariners Bay: Reset limits on primary exit gate operator.
Mariners Bay: Transcore light wasn’t working. The power cycle was off. Turned on power source and the light was operational.
Danbury Bridge: Transcore light wasn’t working. The power cycle was off. Turned on power source and the light were operational.
Ruby Canyon: Installed new motor into primary exit gate operator and the gate was operational.
Canyon Green: The call box was frozen. Power cycled the call box and was now operational.
Tuesday
Mariners Bay: Gate was toggled open because the transcore wasn’t reading tags. Power cycled the transcore and the gate was operational.
Stoney Falls: Transcore light wasn’t working. Power source was off. Turned power source on and the transcore light was working.
Canyon Gate: Replaced old, rusted out, door strike on gate door with a new one. The gate door was working properly.
Wednesday
Newlight Bend: Entry overview camera was out for some time. Gave it a hard reboot and it was now operating properly.
Mallory Bridge: Entry operators malfunctioned. Reset the limits on the operators and the gate was functional (last incident was two weeks ago, Monday).
Call Boxes: Willow Ranch, Willow Fairway, Crimson Canyon, and Harmony Springs. All had trouble transmitting to the Guardshack. Realized they were due for an update on firmware and a few others. Out of these (4), (3) are good. Crimson Canyon was having a hard time implementing the update. Would continue all updates in the morning.
Thursday
Mallory Bridge: Gate wouldn’t close. When it was able to close, the siren/alarm kept going off and it wouldn’t open again. Tried setting the limits again and it worked but also seen that the firmware needed updating. Updated the firmware and now standing by to see what happens next.
Newlight Bend: Exit gate was open. Power cycled the loop indicators and the gate operational
Lost Mills: Cameras were offline and no internet. Power cycled the modem and the cameras were online.
Firmware update: All remaining call boxes - Lost Mill, Bluff Springs, Canyon Green, Island Shores, Ruby Canyon, Stoney Falls, Keystone Fairway, Blevins, Nautical Point, Mariners Bay, Switchback, Danbury Bridge, Newlight Bend, 7&8’s.
Friday:
Mariner's Bay: Entry Gate wasn't opening for residents. The call box was frozen. Power cycled the call box and the call box was operational.
Lost Mills: Cameras and Internet were offline. Power cycled the modem. Cameras were online shortly after.
Blevins: Card reader wasn't working. Power cycled the card reader and then the call box itself. The card reader was operational.
Gates that still remain open: Island Shores, Keystone Fairway, Keystone Fairway Hahns Peak, Switchback, 7&8's. Repairs are scheduled for next week.
| 
