|
How do you set up part-off and pickup programs?
Part-off and pickup operations are where things can go sideways fast if you’re not careful. When you’re transferring a part from the main spindle to the sub, or cutting it free from the bar, small mistakes in synchronization or work offsets can wreck a part, or worse, a spindle. The key is precision, coordination, and a clear plan for both sides of the machine.
Start with solid work offsets.
Set separate work offsets for the main and sub spindles. Zero the part in the main spindle first, then pick up that same reference in the sub. Use your probing system if you have one, or a known gage point on the bar or soft jaw. Both spindles must agree on Z-zero or your pickup move will be off.
Plan your cutoff toolpath carefully.
Leave enough material for a clean part-off, but not so much that it wastes cycle time or risks a burred edge. Keep the cutoff tool sharp and rigid, use coolant and slower feed near breakout to avoid tearing or part pull. If the part is thin or flexible, undercut slightly before the final pass to relieve pressure.
Program spindle synchronization.
Use spindle sync codes (often M-code pairs like M150/M151 or M205/M206, depending on your control) to bring both spindles to the same RPM and direction before the pickup. Verify synchronization in dry run mode before you ever cut. Once synced, close the sub-chuck, pause, then stop the main spindle to let the sub take control.
Control handoff timing.
Add small dwell times after synchronization and clamping commands to give both spindles a moment to stabilize. Machines react differently under sync; rushing transitions can cause torque spikes or part slip.
Set your pickup position precisely.
Approach the part slowly during pickup, typically using G0 close to the face and G1 for the final clamp distance. Confirm grip visually on the first run. If your part length is critical, probe or touch off the sub once clamped to re-establish the correct Z-offset for finishing ops.
Cut off cleanly and clear the chip.
When parting, use high-pressure coolant or an air blast to push the chip away from the cut. A chip caught between the tool and part can gouge the face during handoff. Always retract the cutoff tool fully before the sub pulls back.
Use spindle retract and park moves wisely.
After cutoff, move the sub spindle back smoothly to its safe zone, and stop it before indexing any tools. Avoid fast retracts that can sling coolant or spin the part loose before clamping pressure stabilizes.
Verify every motion in simulation.
Run the whole transfer in your machine simulation with both spindles active. Watch chuck open/close commands, rotation direction, and timing. Many crashes happen not because of bad code, but because of mismatched expectations between the control and the CAM output.
Bottom line:
Part-off and pickup are about coordination, not speed. Sync the spindles, control your offsets, and treat the handoff like a relay race; the cleaner the exchange, the smoother the finish.
Have a programming question?
Send it in for the next edition of Ask a CAM Pro!
|