|
Your tool and spindle must rotate in a specific ratio, like 2:1 or 1:1, depending on the shape. If the sync is off, the geometry won't form correctly. No sync means no polygon.
Use the right insert for the job.
These aren’t your standard endmills. Polygon tools are built rigid, often with flat ground edges, to withstand the repeated impact of high-speed cutting. The wrong tool will lead to chatter, poor finishes, or misshaped features.
Keep the CAM side simple and focus on sync.
You don’t need to model the polygon shape in CAM. Just program a basic turning pass, then call the polygon operation using an M-code or custom cycle that activates the sync settings for the driven tool.
Go easy on depth and feed.
Polygon turning is quick, but it’s not for roughing. Keep the depth of cut light, the feed conservative, and stick to ductile materials. This protects the tool and keeps the shape clean.
Run a test if you can.
Very few CAM systems simulate true polygon motion, but if yours does, use it. Otherwise, dry run the program at a reduced feed or with block skip to confirm the sync is working before running full speed.
Bottom line:
Polygon turning is a fast, efficient way to create non-round features on a lathe, but it only works if the sync is perfect and the tooling is built for the job.
Have a programming question?
Send it in for the next edition of Ask a CAM Pro!
|