Venturi Mixing Hopper

 
Hopper-Image image

DESCRIPTION & RECOMMEDED USE


The Venturi Mixing Hoppers are designed to aid in the introduction of dry powdered drilling fluid, polymers, and additives into a liquid phase, decreasing the time required for mixing and increasing the yield of drilling fluid, polymers, and additives through better shear.


The mounting plate (included with assembly) can be bolted to the side of the mixing tanks or tubs and the hopper can easily be lifted for removal and storage for transporting. 2” hoses with camloc fittings (of appropriate pressure rating) can be used to connect from the pump discharge outlet to the feed inlet of the hopper. The hopper discharge/outlet can be extended or redirected to return into the drilling fluids tank or tub.

  • Portable and easy to install


  • Improves yield - Reduces lumping & waste


  • Accelerates the mixing process


  • Carbon Steel, 18" length x 18"-20" height


  • Feed inlet & discharge fittings: 2" male NPT


  • CME PART #214116

MIXING & APPLICATION


Ensure that pump feed volume is adequate and the hopper is free of plugging before introducing dry material into the hopper. Always follow proper mixing order for drilling fluid, polymers and additives: Soda Ash first, bentonite second, and add polymers and additives after the bentonite has fully yielded (the fluid is free of small lumps of bentonite). Add product slowly to prevent plugging. Clean the hopper before storing.

Pump-Discharge-to-Hopper image
 
PRINT FRIENDLY PDF
UPDATED PRODUCT CATALOG
55LC-300-blue-low-clearance-mode-sm image


CME-55LC/300

TRACK MOUNTED DRILL


The CME-55LC/300 gives you all the power and productivity of the standard CME-55 drill.


A full length mast is provided for every day wide open spaces, but when overhead space is limited, you can easily change over to low clearance mode.


The CME-55LC/300 can set up and drill in as little as 12 foot, 1 inch (3.68 m) overhead clearance, and you still have the full 72 inch (183 cm) feed stroke. Low clearance sheaves permit full use of hoist lines, and the low clearance lifting cylinder allows for normal automatic hammer operation.


Remote control track drive, engine throttle and front carrier winch allow the operator to move freely around the machine. Manual back-up controls are provided for emergency use. Removable steel belly pans provide protection every day and access when needed. Rubber tracks won’t damage pavement.


DRILL FEATURES


SPECIFICATIONS


OPTIONAL EQUIPMENT


BROCHURE



NGWA-Logo-2024 image

Las Vegas Convention Center

December 10th - 12th, 2024


See a CME-55LC/300 track drill on display!


Stop by Booth #139 to speak with an experienced CME representative about your unique drilling needs!



 


FOR MORE INFORMATION,

CALL 1-800-325-8827

EMAIL PRODUCTUPDATES@CMECO.COM

OR VISIT WWW.CMECO.COM


REQUEST A QUOTE!



CME Logo