|
You can hit every dimension dead-on and still end up with chatter marks or surface flaws if your entry and exit moves aren’t dialed in. Clean starts and smooth exits matter, especially when profiling on a lathe.
Use tangential entries instead of plunging straight in. A lead-in arc or angle gives the insert a smooth ramp into the cut, reduces impact, stabilizes chip load, and protects your cutting edge. Straight plunges might look efficient, but they’re brutal on finishes and tooling.
Don’t ramp out mid-cut unless you want gouges. A finishing pass should exit with a clean arc or straight line that’s tangent to the surface. That keeps tool pressure consistent and leaves a better finish; no dragging, no tearing.
Match your lead-in and lead-out angles. Consistency here matters, especially on cosmetic or sealing surfaces. A mismatch in entry/exit geometry can show up as visible transitions or uneven finishes that kill part quality.
Watch for dwell. Even a half-second pause at the start or end of a move can leave a mark. Make sure your code flows smoothly; no hesitation at entry or exit.
And if you’re running tool nose compensation, your lead-ins and lead-outs need to be long enough for comp to kick in before the actual cut starts. Too short, and your dimensions could be off without you realizing it.
Smart toolpaths don’t just cut well, they start and finish clean. Treat the beginning and end of each move like they matter, because they do.
Have a programming question?
Send it in for the next edition of Ask a CAM Pro!
|